Description
Rain Bird FG100 flow sensor
Flo-Watch™️: In a word this functionality in the ESP-ME3 Controller uses information from the FG100 to learn the flow, and monitor for low or excessive flow conditions caused by broken lines or heads—saving water, protecting plants and preventing property flooding.
Winter ready: Especially designed to withstand high-burst pressure blowouts. During winter months, it is not necessary to remove it.
No specialty PE-cable: Another key point is that it’s easily installed, the FG100 with a standard 18g irrigation wire.
Threaded or slip unions: Threaded or slip unions allow for faster installation and easy maintenance.
Rain Bird App: Pair the FG100 with the ESP-ME3 Controller to check system health from anywhere, and control advanced flow settings via the Rain Bird Mobile App. Available for iPhone and Android.
Specs of Rain Bird FG100 flow sensor:
- 1″ / 25.4 mm inlet/outlet NPT/BSP/Slip
- Plastic body
- Paddle wheel impeller with ceramic shaft for heat dissipation
Operating Specification:
500′ / 152.4 m range on standard 18g irrigation wire
Shielded wire is recommended for installations with wire runs that exceed 500′ / 152.4 m, installation sites with significant wireless interference or to help protect against high-lightning locations.
Minimum Flow: 3 GPM / 11.35 LPM
Maximum Recommended Flow: 25 GPM / 94.63 LPM
Maximum Flow: 35 GPM / 132.49 LPM
Rain Bird flow sensors enable you to capitalize on the advantages of Flow Management functionality from controllers and central control. Pulse the pin repeatedly by inserting and removing one pin to simulate flow. Jumping these two pins should simulate flow and the Pulse Count would increase. a. If the Pulse count does increase, there is most likely an issue with the Flow Meter.
Rain Bird FG100 flow sensor
